Raven Viper 4 - Power Button and Status Indicator

Chapter 2
8 Viper® 4 and Viper 4+ Installation Manual
Transfer job reports to a Slingshot user account via either a Slingshot
®
Field Hub or a USB flash drive. The
Slingshot web service is free and does not require any hardware or monthly subscriptions to utilize the
reporting features of the web site. With a Slingshot Field Hub, files may be transferred from the home or office
to the equipment in the field and completed job reports may be transferred back to the home or office via a
wireless network connection.
Power Button and Status Indicator
Viper 4
The Viper 4 features a LED indicator to provide device status information at a glance.
FIGURE 2. Raven Viper 4
Power Status LED. When the Viper 4 is powered up, the LED will flash red for a few seconds and will then
switch to green.
Light Sensor. The light sensor is not currently used with the Viper 4.
Viper 4+
Power Status LED. The power button on the Viper 4+ also doubles as the status indicator. When the Viper 4+
is powered up, the LED will flash red for a few seconds then switch to green.
FIGURE 3. Viper 4+ Power Button and Status Indicator
Power Status
Light Sensor
Power Button/
Status Indicator