CHAPTER
3
Manual No. 016-0171-559 Rev. C 19
C hapter 3
Installation Overview
and Kit Contents
Overview of the Installation Process
The information provided in this section cover basic installation of the Raven Viper
®
4, Viper 4+ and supplied
components. Perform the following procedures to complete installation of a Viper 4 control system:
1. Review Chapter 3, Installation Overview and Kit Contents and verify necessary components are on hand
before starting the installation process.
2. Review to Chapter 4, Mounting the Viper® 4 and Viper 4+ for details on mounting the ROS device.
3. Mount and connect GPS antenna (integrated receiver) or install external GPS components. Review the
DGPS Antenna Mounting Recommendations section on page 25 for assistance with mounting the GPS
antenna.
4. Install any optional CANbus components.
5. Route and connect chassis and console cabling. Refer to Chapter 5, Viper® 4 and Viper 4+ System
Connections.
6. Connect power leads to vehicle battery.
Note: Review the Raven CANbus Network Installation Manual for additional information on building a
CAN (Controller Area Network) system. For instructions on installing additional or optional
hardware with the Viper 4 or Viper 4+, refer to installation documentation provided with the
additional or optional component(s).
To Next Page
Loading...
