Rawling 12108 - Operational Settings; Setting automatic closure; Setting the maintenance signal

52
GB

Press the – button. “7” appears on the
display to indicate that you are in menu 7.
Press on the P button. “0” flashes on the
display to indicate that automatic closure is
switched off.
Press the + button to switch automatic
closure on. “1” flashes on the display.
Press the – button to select how many 30-
minute periods must elapse before the door
closes automatically. You can choose from
1 to 8, corresponding to a time period from
30 minutes to 4 hours.
Press the P button to save the setting.

If you want the door opener to remind you
when it is time for maintenance, you must
set this in menu 8. Press the – button. “8”
appears on the display to indicate that you
are in menu 8.
Press on the P button. “0” flashes on the
display to indicate that the maintenance
signal is switched off.
Press the + button to switch the
maintenance signal on. “1” flashes on the
display.