Raycus RFL-P70Q - Specifications

User’s guide Ytterbium Pulsed Fiber Laser RFL-P70Q～P100Q Ver.: 2.0
2 / 9
6) The device has four cooling fans at the rear panel to dissipate heat. In order to guarantee
enough airflow to help giving heat off, there must be a space of at least 10 cm’s width for
airflow in front and rear side of the device. As the cooling fans are working at blow condition,
if laser is mounted in a cabinet with fans, the direction should be same as laser’s fans.
7) Do not look into the output head of the device directly. Please do wear appropriate laser
safety eyewear during the time when operating the device.
8) Make sure the pulse repetition rate higher than 20 kHz.
9) For the longest time without pulse is only 100 us. If there is no pulse output, please stop
marking at once, to avoid further damage of the device.
10) Power source sudden interruption will do great harm to the laser device. Please make sure
the power supply works continuously.
1.4. Specifications
Table 2. 70Q/100Q pulsed fiber laser specifications
Pulsed fiber laser
70Q
100Q
Wavelength
（
nm
）
1060~1085
1060~1085
Polarization
Random
Random
Optical isolator
Yes
Yes
Nominal average output power (W)
≥70@70～100kHz ≥100@100～200kHz
Single pulse energy (mJ)
1@20～70kHz 1@20～100kHz
Beam quality（M
2
） ≤1.6 ≤1.6
Beam Diameter
（
mm
）
6
～
8
6
～
8
Pulse duration
（
ns
）
50
～
130@70kHz
50
～
130@100kHz
Pulse repetition rate
（
KHz
）
20 - 100 20 - 200
Output Power Tunability（%）
10-100 10-100
Output Fiber Cable length（m）
2.0 2.0
Working voltage（VDC）
24±1 24±1
Power consumption（20℃）（W）
400 450
Cooling
Forced Air Cooled
Forced Air Cooled
Dimension W×D×H（mm）
396×360×123
396×360×123
Operating temperature
0℃～40℃ 0℃～40℃
Store temperature
-20℃～60℃ -20℃～60℃
humidity
＜80% ＜80%