As you pull the locking collar, it clicks into place over the split - ring. The locking collar stays in
position on the connector, but rotates freely.
Makingconnections
Followthestepsbelowtoconnectthecable(s)toyourproduct.
1.Ensurethatthevessel'spowersupplyisswitchedoff.
2.Ensurethatthedevicebeingconnectedtotheunithasbeeninstalledinaccordancewiththe
installationinstructionssuppliedwiththatdevice.
3.Ensuringcorrectorientation,pushthecableconnectorfullyontothecorrespondingconnector
ontheunit.
4.Turnthelockingcollarclockwisetosecurethecable.
RealVision™3Dtransducerextensioncable
Forbestperformance,cablerunsshouldbekepttoaminimum.However,forsomeinstallationsit
maybenecessarytoextendthetransducercable.
•3m(9.8ft),5m(16.4ft),and8m(26.2ft)transducerextensioncablesareavailable(partnumbers:
3m-A80475,5m-A80476,8m-A80477).
•Itisrecommendedthatamaximumoftwocableextensionsareused,withthetotalcablelength
notexceeding18m.
Testingandadjustingthetransducer
Oncetheinitialmountingprocedureshavebeencarriedout,thetransducermustbetestedpriorto
finishingthemounting.
Thetestingshouldbecarriedoutwithyourvesselinthewater,withadepthgreaterthan0.7m(2.3
ft)butlessthanthemaximumdepthrangeofthetransducer.
1.OpentheSonarapplicationonyourdisplay,andselecttheSonarchannel.
Afterafewsecondsthebottomshouldbevisibleonscreenandadepthreadingdisplayed.
2.Startmovingyourvesselatalowspeed,ensuringyouhaveadepthreadingandaclearimageis
displayed.
3.Graduallyincreasethevesselspeedwhilstcheckingthedisplay,iftheimagebecomespooror
thebottomismissingatlowerspeedsthenthetransducerneedstobeadjusted.
19
To Next Page
Loading...
