EasyManua.ls Logo

Raymarine axiom 7 - User Manual

Raymarine axiom 7
114 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
© 2017 Raymarine UK Limited
87298-1Document number:
04-2017Date:
English (en-US)
Installation instructions

Table of Contents

Questions and Answers

  • J
    jonescarmenAug 19, 2025
    What to do if Raymarine GPS product will not boot up?
    • E
      etaylorAug 19, 2025
      If your Raymarine GPS product won't boot up, it could be due to power supply and connection issues. Refer to the solutions for 'Product does not turn on or keeps turning off'. Alternatively, the software might be corrupted. Try re-flashing the latest software from the Raymarine website. As a last resort, on display products, you can perform a ‘Power on Reset’, but this will delete all settings, presets, and user data.
  • K
    kentjesusAug 23, 2025
    Why does my Raymarine GPS keep turning off?
    • J
      Justin HooverAug 23, 2025
      Your Raymarine GPS might be turning off due to several reasons: a blown fuse or tripped breaker (check and replace if necessary, and inspect for cable damage if it keeps blowing), a poor or damaged power supply cable or connection (ensure the cable is fully inserted, check for damage or corrosion, and flex the cable to check for loose connections), incorrect power connection (ensure the installation instructions were followed), or an insufficient power source (check the power supply voltage with a multi-meter under load).
  • J
    John BoydAug 26, 2025
    How to fix a Raymarine axiom 7 that won't turn on?
    • M
      Melissa AndersonAug 26, 2025
      If your Raymarine Monitor doesn't turn on or keeps turning off, here are some things to check: * Make sure the relevant fuses and breakers are in good condition and properly connected; replace them if needed. * Verify the power cable is correctly oriented, fully inserted into the display connector, and locked in place. * Confirm the power supply is wired correctly, referring to the installation instructions if necessary.
  • B
    Brandon MurrayAug 30, 2025
    What to do if Raymarine axiom 7 connection is slow or keeps dropping?
    • C
      Collin JohnsonAug 30, 2025
      If your Raymarine Monitor's connection is slow or keeps dropping, it might be due to: * Wi-Fi performance degrades over distance. Move devices closer together. * Interference being caused by other Wi-Fi enabled or older Bluetooth enabled devices. Change the Wi-Fi Channel of the device you are trying to connect to and retry the connection. * Interference from devices on other vessels. Change the Wi-Fi Channel of the device you are trying to connect to and retry the connection.
  • T
    Tina WrightSep 1, 2025
    How to troubleshoot a Raymarine axiom 7 that cannot find a network?
    • S
      Scott ChaseSep 1, 2025
      If your Raymarine Monitor cannot find a network, consider the following: * Ensure Wi-Fi is enabled on both Wi-Fi devices and rescan available networks. * Some devices may automatically turn off Wi-Fi when not in use to save power. Power cycle / reboot devices and rescan available networks. * Try to enable broadcasting of the device’s network using the Wi-Fi settings on the device you are trying to connect to. * Move devices closer together or, if possible remove the obstructions and then rescan available network.
  • S
    scottscottSep 5, 2025
    What to do if Raymarine Monitor touchscreen is not working?
    • M
      Mrs. Ashley Livingston MDSep 5, 2025
      If the touchscreen on your Raymarine Monitor is not working as expected: * Check if TouchLock is enabled. Swipe your finger from left to right across the Power button swipe area to de-activate the TouchLock. * Ensure you are operating the screen with bare fingers. Bare fingers must make contact with the screen for correct operation. * If there are water deposits on the screen, carefully clean and dry the screen in accordance with the instructions provided.
  • R
    Rachel BruceSep 9, 2025
    Why does my Raymarine Monitor display behave erratically?
    • J
      James MckinneySep 9, 2025
      If your Raymarine Monitor is behaving erratically with frequent unexpected resets, system crashes, or other erratic behavior, consider the following: * Intermittent problem with power to the display: Check relevant fuses and breakers. * Software mismatch on system (upgrade required): Go to www.raymarine.com and click on support for the latest software downloads. * Corrupt data / other unknown issue: Perform a factory reset. Important: This will result in the loss of any settings and data (such as waypoints) stored on the product.
  • D
    Dennis DavisSep 12, 2025
    Why is the Raymarine axiom 7 Monitor mobile application running slowly or not at all?
    • W
      watsonamberSep 12, 2025
      If the mobile application for your Raymarine Monitor is running slowly or not at all, check these things: * Raymarine app not installed: Install mobile app from relevant app store. * Raymarine app version not compatible with MFD software: Ensure mobile app and MFD software are latest available versions. * Mobile apps not enabled on MFD: Enable “Viewing only” or “Remote Control” as required in the Mobile Apps setting on your MFD.
  • S
    stevendavisSep 13, 2025
    What to do if Raymarine axiom 7 Monitor will not start up (restart loop)?
    • K
      kristinevansSep 13, 2025
      In the unlikely event that the Raymarine Monitor will not start up (restart loop) due to software corruption, try downloading and installing the latest software from the Raymarine website.
  • J
    Joseph CarrSep 16, 2025
    Why does my Raymarine Monitor show a “No Fix” GNSS status?
    • J
      James GarciaSep 16, 2025
      The “No Fix” GNSS status icon on your Raymarine Monitor may be displayed due to: * Geographic location or prevailing conditions preventing satellite fix. Check periodically to see if a fix is obtained in better conditions or another geographic location. * GNSS (GPS) connection fault. Ensure that external GNSS connections and cabling are correct and fault free. * External GNSS (GPS) receiver in poor location. Ensure GNSS (GPS) receiver has a clear view of the sky. * GNSS (GPS) installation problem. Refer to the installation instructions.

Summary

Chapter 1: Important Information

Warnings, Disclaimers, and RF Exposure

Covers product installation warnings, disclaimers, RF exposure, and compliance statements.

Chapter 2: Document and Product Information

Compatible Transducers for Axiom MFDs

Chapter 3: Installation

Selecting an Installation Location for Axiom MFDs

Guides on choosing an optimal location considering various factors.

Axiom MFD Mounting Options Overview

Describes different mounting methods like trunnion, flush, and surface.

Trunnion Mounting Procedure for Axiom Displays

Axiom 7 Flush and Surface Mounting Guide

Surface or Flush Mounting with Rear Mount Kit

Chapter 4: Connections

Axiom MFD Connections Overview

Details all available connector types on the MFD.

Axiom MFD Power Connection and Distribution

Covers power supply, fuses, breakers, and distribution.

NMEA 2000 and SeaTalkng Network Connection

Guide for connecting to NMEA 2000 networks.

Axiom MFD Transducer Connection Guide

Axiom Network and Accessory Connections

Chapter 5: Maintaining Your Display

Chapter 6: Troubleshooting

General Axiom MFD Troubleshooting

Axiom MFD Power Up and Boot Troubleshooting

Solutions for power and boot-related problems.

Axiom MFD GNSS and Sonar Troubleshooting

Troubleshooting for GPS/GNSS and sonar systems.

Axiom MFD Wi-Fi and Touchscreen Troubleshooting

Chapter 7: Technical Support

Raymarine Product Support and Servicing Information

Chapter 8: Technical Specification

Axiom MFD Technical Specifications

Details power, environmental, LCD, and data connection specs.

DownVision Sonar Specifications

RealVision 3 D Sonar Specifications

Internal GNSS Receiver Specifications

Chapter 9: Spares and Accessories

Raymarine axiom 7 Specifications

General IconGeneral
Display Size7 inches
Resolution800 x 480 pixels
TouchscreenYes
BacklightingLED
Waterproof RatingIPX6 and IPX7
Chart CompatibilityNavionics, C-MAP, LightHouse Charts
ConnectivityWi-Fi, Ethernet, NMEA 2000
Display TypeLCD
GPSBuilt-in
Operating Temperature-25°C to +55°C
Storage Temperature-30°C to +70°C
MountingBracket or flush mounting
CompatibilityCompatible with Raymarine accessories and sensors
Power Supply12V DC

Related product manuals