2 Insert and secure the left and right handlebars
by pressing the spring-loaded buttons and
inserting them into the T-bar.
3 Make certain BOTH handlebars are properly
locked onto the T-bar.
3
ASSEMBLY AND SET-UP
WARNING:
Keep fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
Unfolding the Scooter for First Time Use
1 To release the folding mechanism, place the
scooter on the ground, put one foot on the deck
plate and pull the Anti-Rattle knob up.
Raise T-bar up until it is securely locked in the
upright position.
Note: To activate the anti-rattle feature twist the knob to the right to tighten. Please note there is no need
to over tighten.
Note: The Anti-Rattle knob is spring-loaded and
will automatically lock in the upright position
when fully upright.
WARNING: Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-bar.
To Next Page
Loading...
Need help?
General
