How to Ride
Place one foot on the baseboard, push forward with the other foot. Steer with both hands on the handlebars.
For enhanced cornering, lean slightly into the direction of the turn.
How to Stop
For controlled stops, apply the brake by stepping on the rear brake. Razor recommends that you practice applying
the brake at various speeds and in an open area free from obstructions before riding your scooter around others.
7
USAGE
Loose Parts
Check and secure all fasteners before every ride. Make sure the
collar clamp, quick-release lever and anti-rattle knob are locked
properly in place before riding.
Replacement Parts
Replace worn or broken parts immediately.
Call 1-866-467-2967 for parts or visit www.razor.com.
Safety Gear
Always wear proper protective equipment, such as an approved
safety helmet, elbow pads and kneepads. Always wear shoes
(lace-up with rubber soles) and keep shoelaces tied and out of
the way of the wheels. Never ride barefooted or in sandals.
Be Careful!
You will see people on TV and maybe even people you know doing
tricks and stunts. These are people who have been practicing on
scooters for a very long time. Don’t try something until you are
ready. Avoid steep inclines and don’t ride too fast — you can lose
control and fall. Skateboard parks are not designed for scooters.
Never ride in traffic or on the street and watch your surroundings
for pedestrians, bikers, boarders and skaters.
Maintain a hold on the handlebars at all times.
PRE-RIDE CHECKLIST
How to Use Kickstand
Press down on kickstand with foot, pull scooter back and up onto kickstand. Do not stand or ride on scooter when kickstand is deployed. Move scooter forward to
retract kickstand.
To Next Page
Loading...
Need help?
General
