Attaching the Flag
3
1 Insert flag into tube hole located on the top left side of frame.
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of
manufacturing and your purchase. Inflate the tires to the correct PSI before first time use.
Lower air pressure can result in a shorter ride time.
Periodically check both tires. Reinflate when needed.
WARNING:
Do not use the Dune Buggy for the
first time until you have inflated
the tires to the correct PSI. Failure
to do so may damage your electric
product and void your warranty.
WARNING:
Do not over inflate, as this could
damage the tire or wheel.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your tires, first make sure the
pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
Using a bicycle style tire pump equipped for a Schrader-type valve, inflate the tires with a pressure gauge
to the PSI indicated on the sidewall of the tires.
SET UP
To Next Page
Loading...
Need help?
General
