not rotate out of alignment with the front wheel under normal circumstances.
Note: The cable and wire assembly from the handlebars must not wrap around the steering tube or
handlebars. Sharp bends or twisting of the brake cable can cause the brake to malfunction.
Inflating the Tire
The front tire is inflated when shipped, but it invariably may lose some pressure between the point of
manufacturing and your purchase. Always inflate tire to the correct PSI before first-time use.
Lower air pressure can result in a shorter ride time. Periodically check tire. Reinflate when needed.
1 Using a bicycle-style tire pump equipped for a Schrader-type valve, inflate the front tire to the
correct PSI indicated on the sidewall of the tire.
WARNING: Do not use the electric scooter for the first time until you have inflated the front tire
to the correct PSI. Failure to do so may damage your electric scooter and void your warranty.
WARNING: Do not over inflate, as this could damage the tire or wheel.
Note: The pressure air supplies found at gasoline stations are designed to inflate high-volume
automobile tires. If you decide to use such an air supply to inflate your electric scooter tire, first make
sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI. If you
inadvertently over inflate the tire, release the excess pressure immediately.
Need Help? Visit our website for replacement parts, product support, a list of authorized service
centers in the US and customer service contact information at www.razor.com. Please have the
product I.D. code (located on the white label of your product) available for better assistance.
Additional Customer Service contact information is listed at the back of this manual.
CHARGING THE BATTERY
Your electric scooter may not have a fully charged battery; therefore you must charge the battery
prior to use.
Initial charge time: 12 hours.
Recharge time: up to 12 hours, even if the light turns green. Recommended maximum charging
time is 24 hours.
Always charge the battery immediately after riding.
Fully charge battery before storing for extended periods of time.
Unplug charger from the wall outlet when not in use.
Failure to recharge battery periodically may result in a battery that will not accept a charge.
Make sure the power switch is turned OFF when unit is not in use. If the power switch is left on for
an extended period of time, the battery may reach a stage at which it will no longer hold a
charge.
To ensure long battery life, never store the product in freezing or below-freezing temperatures!
Freezing will permanently damage the battery.
Run time: Up to 40 minutes of continuous ride time. Run time may vary depending on riding
To Next Page
Loading...
Need help?
General
