HEADLINE
33
BEFORE YOU BEGIN
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because
your scooter was partially assembled and packed at the factory, there should not be any problems, even if the box
has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 8 hours for charge (see page 5 for charging information).
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR RAZOR ELECTRIC
SCOOTER. Razor scooters have
been built to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame and all other parts. Certain
aftermarket components may not
be compatible. Use of non-Razor
parts will void the warranty.
Note: Electric scooter must
be moving at least 3 mph
(5 km/h) while applying
throttle to engage motor.
Product ID Locations:
(See locations to the left)
1. Side of Deck
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• Razor ICON
• Charger
• Owner’s Manual
• 5 mm Allen Wrench
Required Tools and Parts
Grip
Electronic Brake
T-Bar
Collar Clamp
Down Tube
Security Lock Point
Anti-Rattle Folding Mechanism
Folding Cover
Rubber Pad
Kickstand
Frame
Charger Port
Power Cutoff Rear-Fender Brake
Hub Motor
Rear Light (Left / Right)
Front Wheel
Head Tube
Front Fork
Headlight
Handlebar
Clamp
Throttle/Display/
Control Panel
Grip
5 mm Allen Wrench (Included)
2.
Charger
(Note: Charger design may
vary from one shown)
1.
To Next Page
Loading...
