charged until the charger has been repaired or replaced. Use only with the recommended charger. Use caution when charging. The charger is not a toy. Charger should be
operated by an adult. Do not operate charger near flammable materials. Unplug charger and disconnect from product when not in use. Always disconnect from the charger prior to
wiping down and cleaning your product with damp cloth.
FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS FURTHER INCREASES RISK OF SERIOUS INJURY. USE AT YOUR OWN RISK AND WITH
APPROPRIATE AND SERIOUS ATTENTION TO SAFE OPERATION. USE CAUTION.
BEFORE YOU BEGIN
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents that
may have occurred during shipping. Because your scooter was assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
THIS UNIT DOES NOT HAVE A POWER SWITCH. LIGHTS WILL TURN OFF AUTOMATICALLY. UNIT IS ALWAYS ON STANDBY MODE WHEN NOT BEING RIDDEN.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time. Allow up to 4 hours for charge (see page 5 for charging information).
Charger Note: Charger design may vary from one shown
Required Tool
WARNING: DO NOT USE NON-RAZOR PRODUCTS WITH YOUR SCOOTER.
Razor scooters have been built to certain Razor design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the
frame, fork, and all other parts. Certain aftermarket products may not be compatible and will void the warranty.
Note: Electric scooter must be moving at least 3 mph (5 km/h) while applying the footcontrolled power system to engage motor.
Product ID Locations: (See locations to the left)
1. Front Left Side of Deck
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
Electric Scooter
Charger
Owner’s Manual
5 mm Allen Wrench
ASSEMBLY AND SET-UP
Attaching the Handlebars
Tool Required: 5 mm Allen Wrench