10
2 Disconnect the battery
connector from the control module
and carefully remove the battery
from product.
1 Turn product over. Loosen the
Phillips screw on the battery cover
and remove cover.
3 Install replacement battery.
Re-connect the battery connector to
the control module.
4 Re-attach battery cover and
securely tighten in place with screw.
Product Battery Replacement
Tool Required: Phillips Screwdriver
Remote Battery Replacement
Tool Required: Phillips Screwdriver
REPAIR AND MAINTENANCE
1 Loosen Phillips screw on
battery cover and remove cover.
Remove old batteries and
properly dispose.
2 Install two (2) AAA
replacement batteries.
3 Re-attach battery cover
and securely tighten in place
with screw.
Note: AAA batteries are not
covered under the limited warranty.
WARNING:
• Contains a lithium-ion battery
pack - adult attention for
changing and disposal.
• Battery should only be replaced
by an adult.
• Dispose of batteries properly.
See Page 11 – Battery Care
and Disposal.
• Battery pack should not
be disassembled, crushed,
punctured, opened or otherwise
mutilated.
To Next Page
Loading...
