Razor RIPSTIK RUSH User Manual

33
BEFORE YOU BEGIN
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RAZOR RipStik Rush. The
RipStik Rush has been built to
certain Razor design specifications.
The original equipment supplied
at the time of sale was selected
on the basis of its compatibility
with the frame and all other parts.
Certain aftermarket products
may not be compatible and will void
the warranty.
Note: RipStik Rush must be
moving at least 3 mph (5 km/h)
while holding the lever on the
remote in the “GO” position for
motor to engage.
Product ID Locations:
(See locations to the left)
1. Underneath Product
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• RipStik Rush
• Remote
• Two (2) AAA Batteries
• Charger
• Owner’s Manual
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches, or dents that may have occurred during shipping. Because the RipStik
Rush was 99% assembled and packed at the factory, there should not be any problems, even if the box has a few
scars or dents.
MAKE SURE POWER BUTTON IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 6 hours for charge (see page 6 for charging information).
Battery
Remote
On/Off Button
360°
Inclined
Rear Caster
Urethane
Wheel
Remote Holster
Hub Motor
2.
Charger
(Note: Charger design may
vary from one shown)
1.
Charger Port

Razor RIPSTIK RUSH Specifications

General

Brand	Razor
Model	RIPSTIK RUSH
Category	Sports & Outdoors
Language	English