Razor vector - USAGE; How to Ride; How to Stop

7
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
USAGE
7
How to Ride
Do not activate the thumb throttle unless you are on the Vector and in a safe, outdoor environment suitable for riding.
Put kickstand up.
Press the power button (A), the LEDs on the battery display will light up. Press the power button (A) for two
seconds to turn the unit off.
Headlight and Taillight: To activate the headlight and taillight the product must be powered ON. Press the power
button (A) once to activate the headlight and taillight. To deactivate the headlight and taillight, press the power
button (A) once again.
Get on the scooter and place both hands on the handlebars. Press down on the thumb throttle (B).
How to Stop
For controlled stops, apply the brake by squeezing the brake lever (on handlebar). Razor recommends that you
practice applying the brake at various speeds and in an open area free from obstructions before riding your scooter
around others.
When the brake is applied the tail/brake light will blink. The brake light is always functional and independent of the
other lights being activated.
Note: The Vector electric scooter features Regenerative Braking. Regenerative braking is a means of recovering
and converting kinetic energy into stored power. Using the scooter’s electric motor, energy that is usually lost
during deceleration and braking is captured and converted back to stored power extending run time and range.
Regenerative braking only recovers a small amount of energy at a time but can be significant over the course of a full
battery cycle. As always specifications and the amount of recovered regeneration varies with rider weight, terrain,
and environmental conditions.
Speed
Mode
Power
Button
Alarm
Battery
Capacity
Speed
B
A
WARNING: The brake is
capable of skidding the rear tire
and throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control and/or damage the rear tire.
Note: As an additional safety
feature, the scooter is designed to
cut power to the motor when the
brakes are applied.
Note: Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under the limited warranty.