The auto-darkening helmet is a True Color welding helmet. With advanced True Color
technology, the user can weld with improved clarity due to new complex coating technology,
grind with precision while in grind mode and finally see the job performance in the light state in
the full spectrum of colors. There is no need to remove the helmet to see clearly! Results are
enhanced the weld quality, increased efficiency and improved safety!
The auto-darkening helmet needs little maintenance. Use a clean, soft piece of cloth
moistened with soft soap / pure alcohol / commercial disinfectant to wipe the inside and the
outside of the helmet. Dry storage.
Note:Do not immerse the helmet or ADF in water directly.
Trouble Shooting
R
emedy
The ADF does
not darken when
welding.
-Stop welding or cutting immediately.
-Make sure the sensors are facing the arc and no obstructions.
-Check the mode that is on WELD not GRIND.
-Review sensitivity recommendations and adjust sensitivity if possible.
-Replace the battery if necessary.
The ADF stays dark
after welding or there is
no arc present.
-Adjust the sensitivity to the lower level (level 1).
-If the welding place is extremely bright, it is recommended to reduce
the surrounding light level.
The ADF switching
during the welding.
-Increase the sensitivity if possible.
-Make sure the sensors are facing the arc and no obstructions.
-Increase Delay 0.1 − 0.3 second may also reduce switching.
Inconsistent shade
number on the corner of
ADF.
-I
t is a natural feature and will not be dangerous for the eyes.
-In order to get a maximum comfort, try to keep an view angle at around
90°.
The auto-darkening helmets are warranted for 2 years from the date of purchase. The duration
of use depends on various factors such as use, cleaning storage and maintenance. Frequently
inspections and replacement if it is damaged are recommended.
To Next Page
Loading...