CONTROL METHODS HeatNet Control V3
Page 39
POST PURGE This needs to be set on all boilers. All
boilers control their respective DHW
pump/valve when they are called to perform
DHW heating.
SHARING This can be set on any boiler and will
how boilers will cycle on/off when they are
called to perform DHW Heating.
LOCAL PUMP OFF This can be set on any boiler to
determine how the local pump/valve behaves
when called to perform DHW heating.
PURGE TO This does not need to be set on
MEMBER boilers, only the MASTER boiler.
HYB SENSOR: = OFF. This sensor is
selectable for Method 5A only.
NOTE: JPS1 MUST be cut on all boilers
providing DHW. Cutting JPS1 limits to
maximum temperatures to 200F.
To Next Page
Loading...
