DEFAULT SETTINGS & MENU ITEM DESCRIPTIONS HeatNet Control V3
Page 115
CONTROL SETTINGS MENU — PAGE 3
If the OK button is pressed, the factory set MIN, PILOT, and
MAXIMUM blower rates will be loaded
If the OK button is pressed the factory default setting for all menus
are loaded. This does not include the factory calibration values.
LOAD DISPLAY
FIRMWARE BOX
The Display firmware is independent of the HeatNet control’s
firmware. A separate Display firmware file is required in order to
update the display. This needs to be placed on the USB drive and
plugged into the front panel of the boiler.
This file will include any upgraded manuals, drawing, and revision
sheets.
Begin by selecting the file from the USB disk and following the on
screen instructions.
To Next Page
Loading...
Need help?
General