To Next PageTo Next Page
Need help?Do you have a question about the RBI Futera III and is the answer not in the manual?
General| Category | Water Heater |
|---|---|
| Manufacturer | RBI |
| Model | Futera III |
| Voltage | 120V |
| Material | Stainless Steel Heat Exchanger |
| Fuel Type | Natural Gas |
| Capacity | N/A (Tankless) |
| Power | 120V |
| Thermostat | Digital |
| Safety Features | Flame Failure Protection |
Describes the HeatNet control's integrated boiler management system and its capabilities.
Explains the control's use of PID calculations for temperature response.
Details how the control monitors external limits and annunciates faults.
Discusses the HeatNet control's ability to manage multiple boilers.
Controlling multiple boilers using the HeatNet network.
Integrating boilers with Building Management Systems.
Controlling boiler operation via external 4-20mA signals.
Instructions for setting DIP switches for network recognition.
Using RS485 cable and MODBUS protocol for BMS integration.
Direct BMS control of each boiler via BACnet or LonWorks.
Details on using BACnet or LonWorks protocols with a protocessor.
Modulation and setpoint control using external 4-20mA signals.
Explanation of override priorities and control setup.
Using BACnet or LonWorks networks with a protocessor.
How to access the control's setup menus and navigate options.
How to access and interpret the boiler's data log entries.
Details on fault events, their causes, and associated interlock terminals.
Explanation of various status screen fault displays.
Detailed discussion on causes for fault events and required actions.
Detailed discussion on causes for fault events and required actions.
Explanation of faults related to sensors and variable frequency drives.
Troubleshooting issues with boiler detection and H-Net communication.
Addressing issues where only the master boiler fires or flow switch errors.
