Other mnformation
The Remote Control Doesn't Work
Something might be between the remote and the remote sensor on the component. Make sure there is a
clear path.
Maybe the remote isn't aimed directly at the component (DVD,IV,VCR)that you're trying to operate.
Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote.
(Note, ifyou remove the batteries, you may have to reprogram the remote to operate other
components.)
You might need to reset the remote: remove batteries and press the number 1 button for at least 60
seconds. Release the 1 button, replace the batteries, and (if necessary) program the remote again.
Problems with V-Chip/Parental Controls
The rating limits don't work
• You must activate the settings.
I don't remember my password and I want to unlock the TV
• If you forget your passwordyou can resetit. Enter 5898 asthe passwordand then changeit to a new
one.
DVD Problems
Can't advance through a movie
• You can't advancethrough the opening creditsand warning information that appear at the beginning of
moviesbecausethe disc is programmed to prohibit that action.
The invalid icon appears on screen
• The feature or action cannot be completed at this time for one of the following reasons:
• The disc'ssoftware restricts it.
• The disc'ssoftware doesn't support that feature (e.g.,angles).
• The feature is not available at the moment.
• You've requested a title or chapter number that is out of range.
The picture is distorted
• The disc might be damaged. Try another disc.
• If you're using FORWARD or REVERSEbuttons, it is normal for some distortion to appear while scanning.
A sereen saver appears on the TV
• Your player is equipped with a screen saver that appears on the IV after your player has been idle for
several minutes. To make it disappear, press STOPor CLEARon the remote.
Subtitle and/or audio language is not the one selected from the initial setting
• If the subtitle and/or audio language does not exist on the disc, the initial settings will not be seen/
heard. The disc's priority language is selected instead. Set the subtitle and/or audio language manually
through the Info Display or the player menu.
Other Information 27
To Next Page
Loading...
Need help?
General
