15
Flash
Use the Flash/Exit button on the handset to activate custom calling services such as call
waiting or call transfer, which are available through your local phone company.
TIP: Don’t use the Talk button to activate custom calling service such as call waiting, or you’ll
hang up the phone.
Call Timer
After you press Talk or Line plus number button to select the line on the cordless handset,
the built-in call timer shows in the display and begins counting the length of time of the
call.
Out of Range
If the handset is too far from the base (out of range) you may experience static or noise.
Move closer to the base or handset will automatically hang up if it is kept out of range for
30 seconds.
Battery Low
If the handset battery is low, the unit will emit the alert tone and show BATTERY LOW in
the display to remind you that the battery needs charging. If the battery voltage is very low,
the handset will automatically shut down. Place handset in the charge cradle to recharge
battery.
Paging All Extension from the Cordless Handset
In the standby mode, press the Int/Transfer button and then press zero (0) button twice to
activate page all extensions function.
Paging the Cordless Handset
This feature helps you locate a misplaced handset.
Press the Page button once on the base, then press number 0 button. The cordless handset
will beep continuously (if it is not out of range) for 2 minutes or until you press any button
on the handset.
NOTE: You may still page the cordless handset even if the ringer is turned off.
Intercom Operation
Answering an Intercom Call
1. Press the Int/Transfer button or Talk button.
2. When finished, press the Int/Transfer button or Talk button again.
Intercom Operation
To Next Page
Loading...
Need help?
General
