The
camcord
standard VH!
play your
m
VHS cassette
Insert the
m
insert the cas
VHS cassette
Install the
cs
Battery
Compartme
Cover
1. Remove
the
2. Install the
s
negative (-:
in the battei
3. Replace the
Notes:
Replace
than normal.
Remove the batt
month or more.
leakage. If leak,
and replace the I
Insert the ca
1. Before inse
slack in the
cassette.
2. Slide the
E
compartme
xses
a Smaller size cassette, but records in
x-mat. The cassette adapter allows you to
:assettes
in a VCR just like other standard
:assett+
into the cassette adapter and then
te
adarjter
into the VHS VCR like a normal
:tte
adapter’s battery.
.ttery
compartment cover.
blied “AA” battery so the positive (+) and
ds,,
aligh properly with the (+) and (-) terminals
ompadment.
ttery compartment lid.
ba’ttery’ when the load time becomes much longer
from the cassette adapter if it will not be used for a
IS
will drevent possible damage from battery
occur&wipe
up the liquid inside the compartment
3-y with a new one.
o the cassette adapter.
Tape Wheel
g the casse’tte%to the adapter, remove any
le
by turning the tape wheel on the side of the
Compartment
Lid
3f
button to the right to open the cassette
id. I
3. Insert the cassette with the tape window on the left and facing
up. Allow the cassette to drop into the adapter. Do not force
the cassette.
Load
Detect0
4. Gently close the cassette compartment lid until it locks into
place. Make sure the cassette reel area under the adapter is
free to turn while the cassette is loading.
Notes:
You should hear a whirring sound while the tape loads.
The adapter’s load detector will automatically retract into the
adapter.
Caution:
If the load detector is still extending from the
side of the cassette adapter after you have attempted to
load a cassette-the cassette loading is not complete. Try to
load the cassette again. Attempting to insert the cassette
adapter into a VCR while the load detector is extended
may cause damage to the cassette adapter and/or VCR.
Remove the cassette from the cassette adapter.
1. Slide the adapter’s
EJECT
button to the right. The load
detector will extend from the side and a whirring sound
indicates the tape is being released before the adapter’s
cassette compartment lid opens.
2. Use the access hole on the bottom of the adapter to push the
cassette up and remove it from the adapter.
3. Gently close the adapter’s cassette compartment lid.
21
To Next Page
Loading...
Need help?
General
