Electronic Indexing
Each time you begin recording (after the camcorder has been turned off for at least
four hours), the camcorder will automatically record an index mark at the beginning of
the new recording.
When you play back the indexed tape in a VCR that has a compatible indexing feature
called "VHS Index Search System," the invisible marks can be located automatically.
See your VCR owner's manual for index playback instructions.
INDEX
Viewfinder Display
When DISPLAY is pressed so the display
appears in the viewfinder, INDEX will
appear briefly to let you know the
camcorder is recording an index mark.
Note: The camcorder does not record index
marks every time you stop and start recording.
An index mark is recorded only once -- at the
start of each day's recording session (or
whenever the camcorder has been turned off
for at least four hours).
Time Remaining Display ..................................................... ::: :"_=................. ...........':= ..........
The time remaining display shows the amount of recording or playback time left on the
tape in the camcorder.
_---ql
Viewfinder Display
When DISPLAY is pressed so the display
appears in the viewfinder, " "
will appear for approximately ten
seconds when you first start playing or
recording a tape while the camcorder
calculates the time remaining. Once time
remaining has been calculated, it will
automatically be updated and readily
available as long as the same tape
remains in the camcorder.
21
To Next Page
Loading...
Need help?
General
