Date/Time and Title Display -- Recording
The clock cell must be installed and the date and time set (as shown on the previous
pages) before the date and time can be selected and recorded. You must have created
a title (as described on page 43) before your title can be selected and recorded.
_ET Button
SELECT
Button
Select Date, Date and Time, or Title to Record On Your Tape
1. Attach a power supply and place
POWER switch in CAMERA. The
power indicator will light.
2. Make sure the AE dial is not set to
A UTO if you want to select any mode
except AUTO DATE.
3. Repeatedly press SELECT until
P.DISP.4 appears in the viewfinder.
4. Repeatedly press SETto select AUTO
DATE, date, date and time, title, or no
date display.
• AUTODATE: The date will be
automatically recorded for approxi-
mately five seconds and then AUTO
DATE will be displayed whenever:
• The date has been set or
changed.
• This display mode has just been
selected.
• The tape has been changed or the
tape compartment opened.
• Date Display: The date will be
displayed and recorded.
• Date and Time Display: The date
and time will be displayed and
recorded.
• Title: The title you have created
will be displayed and recorded. If
no title has been created, SET
CHAR appears.
• No Display: No display will be
displayed or recorded.
40
To Next Page
Loading...
Need help?
General
