221125 Remote Control
This remote control lets you operate the
camcorder from across the room. Uses
one 3-volt micro lithium battery.
lCVA147C RF Output Adapter
This RF output adapter is used with a
coaxial RF cable, such as AH065G or
AHO66G, to connect your camcorder to a
standard TV (one without audio/video
inputs) for playback. If your antenna
cable is the flat twin-lead type attached by
two screws, you will also need a 300-75
ohm transformer such as 193983. If your
TV has 300 ohm VHS screw terminals,
you will need an optional 75-300 ohm
transformer such as AH01 1.
AH25 Y-Adapter
This Y-adapter allows you to connect
your camcorder’s mono audio cable to a
stereo TV or VCR.
Coaxial RF Cables
AHO65G
(64)
AH066G
(lo-ft)
These RF cables are used with the RF
output adapter to connect your camcorder
to a standard TV (one without
audio/video input jacks) for playback. If
your antenna cable is the flat twin-lead
type attached by two screws, you will also
need a 300-75 ohm transformer such as
193983. If your TV has 300 ohm VI-IS
screw terminals, you will need an optional
75-300 ohm transformer such as
AHOll.
193983 Cable Transformer
This 300-to-75 ohm transformer is used to
connect a standard (300 ohm) antenna
twin-lead to a standard round 75-ohm
connector.
AH011 Cable Transformer
This 75-to-300 ohm transformer is used to
connect a standard 75-ohm antenna cable
(such as AH065G or AHO66G) to the
300-ohm screw terminals on a TV.
3
To Next Page
Loading...
Need help?
General
