Insert Cassette into Cassette Adapter
(COII~~~W-I)
Load Detector
4. Gently close the cassette compartment
lid until it locks into place. Make sure
the cassette reel area under the adapter
is free to turn while the cassette is
loading.
Note:
You should hear a whirring sound
while the tape loads. The adapter’s load
detector will automatically retract into the
adapter.
Remove Cassette from Cassette Adapter
~
1. Slide the adapter’s EJECT switch to
the right. The load detector will
extend from the side and the whirring
sound indicates the tape is being
released before the adapter’s cassette
compartment lid-opens.
2. Use the access hole on the bottom of
the adapter to push the cassette up and
remove it from the adapter.
3. Gently close the adapter’s cassette
compartment lid.
41
To Next Page
Loading...
