Chapter 3: Recording CDs
20 Chapter 3
Recording from an External Source (Analog)
If you don’t have the option of recording from a digital source, you may need to make an
analog recording.
1. Put a blank disc in tray B.
2. Make sure the CD, tape, etc., is ready in the external source.
3. Make sure the track numbering is set correctly. You can choose between AUTO and
MANUAL by pressing the AUTO/MANUAL button.
• AUTO — track numbers are automatically incremented after a silence of 3
seconds or more on the source material.
• MANUAL — track numbers can be manually incremented by pressing the
SKIP/SEARCH right arrow button.
Important: Track numbers can’t be changed after recording.
4. Press and release SOURCE IN until ANALOG appears.
5. Press REC (REC flashes).
6. Press PLAY/PAUSE on side B of the unit, then start the external source audio.
7. If you selected manual track numbering, add tracks as needed.
8. When finished recording, press STOP (BUSY appears, followed by UPDATE ).
•To add 3 seconds of silence to the beginning of the track, press PLAY/PAUSE.
•To check the remaining recording time, press REMAIN.
•To temporarily stop recording, press PLAY/PAUSE. To continue recording, press
PLAY/PAUSE again.
15920520.03 Recording CDs 9/24/02, 3:55 PM20
To Next Page
Loading...
Need help?
General
