14 Chapter 1
Connections & Setup
Removing the power supply
1. Make sure the Power dial is set to OFF.
2. Unplug the power supply from the AC outlet.
3. Unplug the small end of the power supply from
the POWER jack on the camera.
Important: Before detaching the power
source, make sure the camera’s power is
turned off. Failure to do so can result in a
malfunction.
Note: Removing the power supply and
batteries from the camera returns all settings
to the factory defaults but does not erase any
information on the CompactFlash card.
Using an Optional Plug Adapter in Foreign
Countries
Even though the power supply is 110/240 volts, an
optional plug adapter might be required in some
countries.
1. Plug the power supply’s plug into the AC plug
adapter.
2. Plug the AC plug adapter into the AC outlet.
FLASH
TIMER
MODE
ON
S
E
T
U
P
V
I
E
W
O
F
F
Power dial
To Next Page
Loading...