Important Safety Instructions
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third
prong is provided for your safety. Ifthe provided plug does not fit your outlet, consult an electrician for replacement
of the obsolete outlet.
10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where it exits from the apparatus.
11.Only use attachments/accessories specified by the manufacturer. _-_
12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injuryfrom tip-over.
13.Unplug this apparatus during lightning storms or when unused for long periods of time.
14.Refer allservicing to qualified service personnel. Service is required when the apparatus is damaged in any way, such
as power-supply cord or plug damage, liquid spilled on or objects falling onto apparatus, rain or moisture exposure,
abnormal operation, or if the apparatus has been dropped.
15.Ifan outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so
as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical
Code, ANSI/NFPA No. 70-1984 (Section 54 of Canadian Electrical Code, Part 1) provides information with respect to
proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size
of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for
the grounding electrode. See following example:
ANTENNA
LEAD IN
WIRE
GROUND CLAM P
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTOR S
(NEC SECTION 810-21)
S
ELECTRIC SERVICE POWER SERVICE GROUNDING
EQUIPMENT ELECTRODE SYSTEM
(NEC ART 250, PART H)
To Next Page
Loading...
Need help?
General
