Powering Your Camcorder
Using the Adapter/Charger to Power Your Camcorder
The adapter/charger attaches to the camcorder and lets you power your camcorder
directly from standard household power. The adapter/charger operates on 100-240
volts, 50/60 Hz, so it can be used virtually anywhere in the world to power the
camcorder or recharge the battery.
To AC 100-240V, 50160 Hz
POWER
Indicator
__ Adapter/Charger
OUT Jack
Attach Adapter/Charger
1. Connect one end of the DC cable
to the DC OUT jack on the
adapter/charger.
2. Connect the other end of the DC cable
to the DC IN jack on the camcorder as
shown above.
3. Plug the adapter/charger's plug into
the nearest AC outlet (100-240V,
50/60Hz).
4. If the adapter/charger is properly
connected, its POWER indicator will
light.
Caution: Do not use this adapter/
charger for any other purpose other than
charging the 236130, FB 1260, or FB 120
battery pack or supplying power to the
camcorder.
Remove Adapter/Charger
1. Unplug the adapter/charger from the
wall outlet.
2. Remove the DC cable from the
adapter/charger and camcorder.
Using an Optional Plug Adapter
An optional plug adapter may be required
in some countries.
.
,
_@1_ _AC _€
Optional
7Y AC 100-240V
Plug Adapter
Plug the adapter/charger's plug into
the AC plug adapter.
Plug the AC plug adapter into the
AC outlet.
12
To Next Page
Loading...
