Playback
Load Detector
4. Gently close the cassette compartment
lid until it locks into place. Make sure
the cassette reel area under the adapter
is free to turn while the cassette is
loading.
Note: You should hear a whirring sound
while the tape loads. The adapter's load
detector will automatically retract into the
adapter.
Caution: If the load detector is still
extending from the side of the cassette
adapter after you have attempted to load
the cassette, loading is not complete.
Try to load the cassette again.
Attempting to insert the cassette adapter
into a VCR with the load detector
extending may cause damage to the
adapter and/or VCR.
Remove Cassette from Cassette Adapter
Access Hole
Reels
Caution: Do not touch the reels
during loading or unloading. It
could cause injury or damage the
cassette adapter or tape.
,
Slide the adapter's EJECT switch to
the right. The load detector will
extend from the side and the whirring
sound indicates the tape is being
released before the adapter's cassette
compartment lid opens.
2. Use the access hole on the bottom of
the adapter to push the cassette up and
remove it from the adapter.
3. Gently close the adapter's cassette
compartment lid.
49
To Next Page
Loading...
Need help?
General
