Trouble Shooting
Problem
Indicator light not blinking when
you press any button
The Remote does not
operate your device
Not performing commands
properly
Problems programming a TV/VCR
Combo Unit
VCR not recording
Channel up and down do not
function on an RCA TV
Problems changing channels
No response after pressing
a button
Sleep feature does not work
Solution
A) Replace the batteries with 2 new
AAA Alkaline batteries.
B) Check that batteries are
properly installed.
A) Try all the codes listed for your
brand.
B) Try the Code Search method
(page 11).
Start Code Search over again to
locate the proper code.
Try the VCR code for your brand.
Some combo units, however, may
require both a TV and a VCR code
for full operation.
As a safety feature on your remote,
you must press the REC button
twice.
Due to some designs, the original
remote will only perform these
functions.
If your original remote required
ENTER after a channel, press
ENTER after you select a
channel.
A) Make sure you have new batter-
ies, and you are aiming your remote
at your devices.
B) Check that batteries are properly
installed (See page 3).
Remote must remain aimed at tele-
vision after sleep is set in order for it
to work.
Note: Reprogramming may be required after batteries are removed.
For Customer Service, contact the RCA Help Center at: www.rca.com
16
To Next Page
Loading...
Need help?
General
