Battery Installation
Your Universal Remote requires 2 new AAA alkaline batteries.
To install the batteries:
1. On the back of the remote, push and slide the cover off.
2. Match the batteries to the + and - marks inside the battery
case, then insert the batteries.
3. Press and slide the battery cover back into place.
Note: Reprogramming may be required after batteries are removed.
INDICA
TOR LIGHT
The Indicator Light flashes to show that the remote is working.
ON•OFF
The ON•OFF button operates the same as your original remote Note:
Some RCA, GE and ProScan models require you to press the device button
to turn the device on and the ON•OFF button to turn the device off.
CODE SEARCH
Used to program the remote or to search through codes.
TV
, VCR, DVD•AUX, DBS•CABLE
The TV, VCR, DBS•CABLE, and DVD•AUX buttons are used to select the
device you want to control.
REVERSE, PLA
Y, FORWARD, RECORD, STOP, PAUSE
The REVERSE, PLAY, FORWARD, RECORD, STOP, and PAUSE buttons
operate the same as on your original VCR or DVD remote. You must press
the RECORD button twice to begin recording.
TV•VCR
When in VCR mode, the TV•VCR button operates the TV•VCR function
of your VCR.
ENTER
The ENTER button is used to complete channel selection for some brands
of TV. It is also used to complete the code entry process, finally, it is used
in Menu Mode as a Select or OK.
VOL & CH
The VOL (Volume) and CH (Channel) buttons increase or decrease the
channel numbers or volume.
MUTE
To MUTE the volume on the TV.
PREV CH
PREV CH allows you to go to the previous channel you selected. Operates
the same as Last Channel, Go Back or Recall button on your original
remote.
0-9
The number buttons operate the same as on your original remote, and are
used for entering device codes or channel numbers.
MENU
The MENU button calls up the TV, DBS and DVD set up menus.
SLEEP
The SLEEP button allows you to set a time to turn off the TV automatically.
Button Description
3
To Next Page
Loading...
Need help?
General
