Selecting Tuner Band
1. Press SOURCE on the main unit or TUNER on
the remote control to enter Tuner mode.
2. Press BAND to select between AM or
FM Radio band.
Tuning to a Station
Press SKIP BACKWARD / SKIP FORWARD
on the main unit or TUNING or on
the remote control to select frequency.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in preset mode,
• Press TUNE/PRESET on the main system or
PRESET or on the remote control to
access the previous or next preset station.
• The display first shows the preset program
number and after a few seconds, the preset
program and frequency will be displayed.
Auto Preset Programming
(FM Only)
Press and hold BAND button for 2 seconds to
scan stations in FM band. The stations will then
be stored as preset channels. A maximum of 32
stations can be stored. Beware of your preset
channels being erased accidentally because the
scanning and storing process is automatic upon
pressing the button. You can stop the automatic
scan by pressing any button, but the erased sta-
tions cannot be recovered.
Manually Setting Presets
1. Press SKIP BACKWARD / SKIP
FORWARD to access the desired
frequency.
2. Press the PROG/SET button once.
3. The most recently accessed program location
will flash on the display.
4. If a different program location is preferred,
press SKIP BACKWARD or SKIP
FORWARD on the main unit or PRESET
or on the remote control to move to
the desired preset number (1-32).
5. Press PROG/SET to store the selected
frequency at that preset.
Suppressing Stereo Signal
Press ST/MONO on the main unit or FM ST. on
the remote control to toggle between FM mono
and stereo for stereo FM stations.
10
EN
Radio
PR 01 FM
07 87.90
Tips:
Your audio system has 32 preset stations.
PROG
MHz
To Next Page
Loading...
Need help?
General
