Remote Control
ON/STANDBY - Turns power on or off from
standby mode.
CD - Selects CD player.
TUNER — Selects radio tuner.
AUX - Selects external input.
TIMER - Enters timer setting mode; Turns on/ off
timer.
SLEEP - Press to select the time interval in
minutes before the unit turns off.
EQ - Selects equalizer presets.
X-BASS - Turns on or off Bass Boost.
REPEAT - Repeats a track, CD or all CDs in CD
mode.
SHUFFLE - Turns on/off random listening in
CD mode.
FM ST • - Selects between stereo and mono
sound in FM tuner mode.
INTRO - Turns intro mode on or off to play the
first 10 seconds of each track in CD mode.
MUTE - Mutes audio output.
CD INFO - In CD mode, Selects display options to
show track elapse time, track remain time or disc
remain time.
PRESET / - Selects next/ previous preset
station. In Clock or TImer mode - Increases /
decreases the hour or minute digit.
VOL or - Decreases or Increases volume
level.
STOP - In CD mode - Stops CD playback; In
program mode - Clears program.
PLAY/PAUSE - In CD mode - Plays and
pauses CD.
SKIP BACKWARD - In CD mode - Goes to
the previous CD track and setting options;
searches backward through CD; In Tuner mode -
Tunes down radio frequency.
SKIP FORWARD - In CD mode - Goes to the
next CD track and setting options; searches
forward through CD; In Tuner mode - Tunes up
radio frequency.
OPEN/CLOSE - Opens and closes disc
compartment.
DISC SKIP - Skips to the next disc in CD mode.
Installing Batteries
The remote control must be inserted with 2
"AAA" or "UM-4" or "R03" batteries prior to use.
Follow the steps below to ensure correct
installation.
1. Remove the battery compartment door
(located at the back of the remote control) by
sliding the compartment door in the direction of
the arrow and then lifting the door out and off
the cabinet.
2. Before inserting the batteries, observe the
polarities (that is, + and -) of the battery, then
relate the polarities to the engraved diagram
inside the battery compartment. Now insert the
batteries.
3. After installation of the batteries, replace the
battery compartment door in place by sliding it
in the
opposite direction of the arrow (the reverse of
step 1).
4
EN
General Controls
To Next Page
Loading...
Need help?
General
