51
Receiver/Tuner Operation
STEREO indicator is off.
• Adjust the antenna.
• The signal is too weak. Connect an external antenna.
• The signal is Mono.
Severe hum or noise.
• The signal is too weak. Connect an external antenna.
• Adjust the antenna.
Remote Control Operation
The remote control does not operate the unit.
• Another function is selected on the remote. Press the
correct function button.
• The batteries are exhausted. Replace all batteries.
• The remote is not pointed at the remote control sensor on
the main unit or there is an obstacle between the remote
and the main unit.
• The remote control is too far from the main unit.
Move closer.
General
No audio.
• Make sure the MUTE indicator on the front panel is off.
• Make sure the speakers are turned on.
• Check the connections.
• Check the power cord connection.
No audio from one channel.
• Adjust the balance control.
• Check the speaker wire connection or connecting cable.
Noise when the TV is turned on.
• The TV is too close to the audio system.
Specific instruments sound displaced.
Appendix c: Troubleshooting
To Next Page
Loading...
