RCA VR634HF - Changing the Signal Type

4.
AUTO CHANNEL SEARCH
What type of signat
are you using?
I Cable TV
2 Antenna
3>Detect Automatically
0 Cancel
Select one of the three AUTO CHANNEL SEARCH options:
Cable TV searches for cable channels
Antenna searches for local broadcast stations
Detect Automatically will make this decision for you
AUTO CHANNEL SEARCH
Now scanning channel 14
Press any key to cancel
The VCR begins scanning for the available channels--this
takes about one to two minutes. When the scan is complete,
the VCR tunes to the lowest channel number. At this point,
pressing CHAN up or down on the remote control or VCR
should only select the active channels.
CHANGING THE SIGNAL TYPE
I. PressMENU to display the VCR MAIN MENU.
2. Press4 to display the CHANNELS menu.
CHANNELS
1 Auto Channel Search
2 Addlgemove Channels
3 Signal Type: CABLE
4 VCR Plus+ Channel List
5 Cable Box Setup
0 Exit
3. Press 3 to change the Signal Type between CABLE and
ANTENNA.
Detect Automatically
A strong cable or antenna signal in
your area may cause Auto Detect to
mis-detect. If this should happen,
select 1 or 2 for the system you have.
W
11