TROUBLESHOOTING TI PS (CONT.)
STEREO AUDIO TOO NOISY
• Stereo signal isweak. Set reception: STEREO/SAP/MONO feature
to MONO.
• Press one of the TRACKING up or down buttons to minimize the
noise.
INDEX AND GO-TO SEARCH FEATURES DO NOT OPERATE
• Check to see if MOVIE _ ADVANCE feature is activated.
CANNOTACCESS MOVIE ,,ADVANCE FEATURE
• Cassette must have safety tab removed and be recorded in SP speed.
• Home Recording was selected for the tape type in the menu. Eject
cassette and reinsert.
VCR FORWARDS TH ROUGH COMMERCIALS OR
MOMENTARILY DISPLAYS A BLUE SCREEN DURING
PLAYBACK.
• Commercial Advance Playback feature isset to AUTO. Set it to
MANUAL.
COMMERCIAL '_ ADVANCE FEATURE DOES NOT MARK
COMMERCIALS WHEN:
• The Marking feature is set to OFF in the COMMERCIAL ADVANCE
menu. Set it to ON.
• A recording is less than 15 minutes or the commercial is longer than
one minute.
• A single isolated commercial can not be marked.
• Recording started in the middle of a commercial segment.
A commercial group within the first or last two minutes of a
recording.
• Accuracy and effectiveness can vary depending upon program
content and the characteristics of the commercials.
• A commerdal is between 30-and-45 seconds and 45-and-60 seconds.
• Effectiveness may vary when local television stations insert their
own commercials.
COMMERCIALS RECORDED EVEN THOUGH COMMERCIAL
I_, ADVANCE FEATURE WAS SET TO ON.
• COMMERCIAL I_, ADVANCE is designed to record the commercials,
mark them, and then skip over the marked commercials during
playback.
66
To Next Page
Loading...
