RCbro SPARROW 2 - Remote Control

RCbro
®
SPARROW 2 User-Manual
LefeiRC www.lefeirc.com/
➢ CRSF-TELE
3. REMOTE CONTROL
➢ How to judge whether the RC is normal?
After the PC is powered on, all the LEDs are on, and the GPS configuration starts. The 3
green lights flash at the same time, indicating that the GPS configuration is completed,
and the RC is not recognized; when the green light T and V flash rapidly at the same
time, the RC has been recognized.
* When power-on, the sensor takes 15 seconds to initialize, please keep the FC level.
*The green light T and V flash quickly and the △ is on, indicating that the RC signal has been
recognized, but the roll or pitch has a large trim or the throttle is not at the lowest position.
➢ How to use the RC to unlock the FC?
Step 1: Keep the throttle at the lowest position after power on;
Step 2: Push the throttle to the highest position;