RCF spa ART 9-AX Reference Guide 10
5. SETTINGS
From Mixer view, pressing the EDIT button (lower left) leads to the SETTINGS page.
The EASY/ADVANCED button allows for a global settings of editing complexity (see par. 3).
SYSTEM SETTTINGS brings to further subpages to handle system setup in all its details.
STEP-BY-STEP CONFIGURATION is a wizard-like approach to quickly configure the system.
Step-by-Step Configuration
The ART 9-AX engine can be deployed in several different configurations; to simplify the setup, a guided step-by-step configuration sequence is
available to properly set all the required parameters.
Three options are available:
SYSTEM SETTINGS
INPUT WIZARD
INITIALIZATION
The INITALIZATION section initializes audio parameters. It is useful for working on the unit starting again from a “clean” setup.
INIT MIXER
All the parameters, related to input
channels only, are set to default
values
INIT ALL
All the parameters related to input
and output channels are set to default
values
INIT AUDIO
This is a debug feature only
The SYSTEM SETTINGS section requires multiple steps to properly configure the system, either with one ART 9-AX speaker or two one ART 9-AX
speakers paired via wireless. The unit is configured without modifying audio-related parameters. Therefore, to adjust a crossover of an output
EQ, you will need to go the specific page.
Depending on intermediate selections, it will require from 3 to 5 steps; the last step will show all choices, which are going to be applied only
after pressing the OK button. If you press the CANCEL button, no changes will be applied.
To Next Page
Loading...
Need help?
General
