RCF spa ART 9-AX Reference Guide 4
SINGLE MODE, MONO SINGLE MODE, STEREO SINGLE MODE; CROSSOVER
Dual Mode
If two ART 9-AX products are available, it is possible to control them from the same LiveRemote app, with a reduced parameter count.
This mode is best suited for direct control from an external mixer, as the internal ART 9-AX mixer becomes less practical.
BLUETOOTH should be set in DUAL modes; the LiveRemote app discovers the PRIMARY speaker, which connects to the SECONDARY speaker
via a private wireless link.
DUAL MODE, STEREO DUAL MODE, ZONE
The dual-speaker system can operate in one of the following MIXER modes:
MIXER mode
DUAL L/R
Each speaker operates as either LEFT or RIGHT when fed from an external stereo signal pair. MIX OUT can be either the main
output or the crossover subwoofer feed.
EDIT mode is forced to EASY (no input EQ and Compressor, no output EQ). Reverb is disabled.
Bluetooth audio feed is handled as a stereo source and correctly routed.
ZONE
Each speaker operates as an independent unit with respect to output settings. MIX OUT can be either the main output or the
crossover subwoofer feed.
EDIT mode is forced to EASY (no input EQ and Compressor, no output EQ). Reverb is disabled.
Bluetooth audio feed is mixed to mono.
All available modes can be enabled by either using the STEP-BY-STEP CONFIGURATION or using the dedicated submenus:
SETTINGS > SYSTEM SETTINGS > BLUETOOTH
SETTINGS > SYSTEM SETTINGS > AUDIO SETUP > MIX OUT MODE
More details are available in the Operating Modes Reference section, later in this document.
To Next Page
Loading...
Need help?
General
