24
ENGLISH
OUTPUT MENUS
Each output channel of the DX 4008 has a separate menu key. There are 6 menus for each output
channel.
SIGNAL - SIGNAL PARAMETERS
OUT_1:XXXXXX MENU: Signal
LEVEL: 0.00dB
POL :+
DELAY: 0 (000.000ms)
• Refer to the Input Menus for details
EQ - EQ PARAMTERS
OUT_1: XXXXXX MENU: EQ
EQ# : 1 BW: 0.33oct
LEVEL: 0.00dB Q=4.36
FREQ :1000Hz TYPE: Param
• Refer to the Input Menus for details
XOVER - CROSSOVER PARAMETERS
OUT_1: XXXXXX MENU: XOver
FTRL: Off FTRH: Off
FRQL: 1000Hz FRQH: 1000Hz
SLPL: 24dB SLPH: 24dB
• FTRL - Filter Type of low frequency crossover point (high pass).
Types can be Buttwrth (Butterworth), Link-Ri (Linkritz Riley) or Bessel.
• FRQL - Filter cut-off Frequency of low frequency crossover point (high pass).
Ranges from 20 to 20,000Hz in either 1Hz steps or 1/36 octave steps. The frequency steps can be
selected in the System Menu.
• SLPL - Filter Slope of low frequency crossover point (high pass).
Ranges from 6 to 48dB/octave (48kHz) or 6 to 24dB/octave (96kHz) in 6dB/octave steps.
If the selected Filter Type is Linkritz Riley, the available slopes are 12 / 24 / 36 / 48 dB/octave
(48kHz) or 12 / 24 (96kHz).
• FTRH - Filter Type of high frequency crossover point (low pass).
• FRQH - Filter cut-off Frequency of high frequency crossover point (low pass).
• SLPH - Filter Slope of high frequency crossover point (low pass).
To Next Page
Loading...