Turn the rear stacking bracket of the flybar and select the
proper angle. The correspondence of the bracket’s holes is the
following:
Insert the locking pin in the proper position
Fix the next module with the front quick lock pins. Lift the
rear part of the module, insert the locking pin in the proper
position and release the module leaning with the right angle.
Repeat this operation for the following modules.
Stacking Bracket Rear Rigging Frame
5 1,7
4 Loose Pin Housing WHITE
3 C 0,7
2 C 2,7
1 Loose Pin Housing WHITE
0 C 0,7
-1 Loose Pin Housing YELLOW
-2 Loose Pin Housing WHITE
-3 Loose Pin Housing YELLOW
-4 Loose Pin Housing YELLOW
To Next Page
Loading...
