DIGITAL INCUBATOR
18
6. Product Information
(2
) Troubleshooting
Troubleshooting
CIRCUMSTANCE ITEMS TO BE CONFIRMED SOLUTIONS
Alarm sounds with
HI indication
(abnormal high temp.)
Alarm sounds with
LO indication
(abnormal low temp.)
▶ Connect the cord again.
▶ Check the main socket with any other
electric appliances.
▶ Try to insert to another outlet.
▶ Check electric cord is properly connected.
▶ Check if there is a power outage.
▶ Check whether the plug is damaged.
Temperature will
not go high enough.
No signs of power
to the incubator.
▶ Check your setting temperature.
▶ Check the air circulation FAN is working.
▶ Initialize the incubator.
[Refer to the page 11]
▶
Set the temperature as required.
▶
Take the power plug out of the outlet, and
disassemble the main body for cleaning
around the air circulation fan with brush.
▶ Supply water.
▶ Set the humidity again as required.
▶ Check your setting humidity.
▶ Close the view window again after checking.
▶ Initialize the incubator. [Refer to the page 11]
Humidity will not
go high enough.
Egg-Turning fails
to work.
▶ Check that the Egg-turning stoppage is not
activated. (Egg-turning lamp lighting)
▶ Check that there are no foreign items on the
egg turning tray.
▶ Check if egg turning plate is assembled correctly.
[Refer to the page 9]
▶ If you need to turn the eggs, you can
manually re-start egg-turning.
▶ Unplug the power supply and
disassemble the main body for cleaning
the egg turning tray and gear.
▶ Assemble egg turning plate as the picture on page 9.
Dew foams in
the incubator.
▶ Check the incubator is not placed
too cold circumstances.
▶ When you turn OFF incubator and then
turn on.
▶
Move the incubator to where the ambient air
temperature is over
28℃ (82.4℉)
▶ Dew condensation is normal.
▶ Dry the incubator completely under well ventilated place.
▶
Take out the plug out of the outlet and
disassemble the main body and clean
around the air circulation fan with brush.
▶ Check if there is any hatching debris such as
feather or eggs-shell in the incubator FAN.
The machine makes
some noise.
- It is normal that the machine
emits some sounds because
it uses air circulation fan
for working.
▶ Check that you have not overfilled the incubator.
▶ Check that the incubator placed on inclined
surface.
▶ Check if it is Dew condensation
Water leaks from
the machine.
▶ Do not fill water over LIMIT indication.
▶ Place incubator under a level surface.
▶ Check if room temperature is too high
▶ Check if incubator is exposed to the direct
rays of sun
▶ Check if room temperature is too low
▶ Check if incubator heater(temperature controlling-
system) is normally working
▶ Adjust room temperature 28℃ (82.4℉)
▶ Install incubator without the direct rays of sun
▶ Return incubator to factory setting [Refer to page 11]
▶ Adjust room temperature 28℃ (82.4℉)
▶ Place thermometer inside of incubator and check
if setting temperature is correct
▶ Return incubator to factory setting [Refer to page 11]
Be sure that the incubator works without any problem before placing eggs in the incubator.
For more detail, please check our website at
www.Rcom.co.kr diagnosis
To Next Page
Loading...
