RCS EPSILON ES4 User Manual

EPSILON ES2,ES4
27
On the panel "Parameters of data exchange" factory settings are shown. Pressing the button
“APPLY” you will save changed parameters, and pressing the button “RESET”
you will cancel changes. When you click on “FACTORY SETTINGS”
all settings will be reset to initial state that corresponds to the factory
settings.
To continue the work you have to press “NEXT” , to return to the previous tab - pres
the button “BACK”.
Next, to continue the work (calibration) you should choose the length of the probe, after
measuring the depth of the tank. After that you need to screw the probe to the measuring head.
If the probe has a standard factory length, in the window "Type of probe" you have to select the
type, appropriate to the length of the connected probe.
If the probe was cut, it is necessary to make the procedure of measuring of the length of the
probe. For this you need to press
“
Auto detection of probe’s type”
. After that, the program will automatically determine the length
of the probe and offer a suitable type of the probe.

RCS EPSILON ES4 Specifications

General

Brand	RCS
Model	EPSILON ES4
Category	Accessories
Language	English