RCS TBZ48 User Manual

DCN: 141-02071-01 Page 2
Setting the heating or cooling temperature setpoint
! To change the Heat Setpoint you must be in the Heating mode, to change the Cool
Setpoint you must be in the Cooling mode. Pressing the Mode button will switch
between the Heat and Cool setpoints.
Setpoint Push: Note that you cannot lower the cooling setpoint below the heating
setpoint. The thermostat will “push” the heating setpoint lower if you try to lower the
cooling setpoint below the heating setpoint. It maintains a 3 degree separation between
the heating and cooling setpoint. The same is true for raising the heating setpoint above
the cooling setpoint. Again the thermostat will “push” the cooling setpoint up to maintain
the 3 degree separation.
Lower
Temperature
Raise
Temperature
Press a button to
go to the setpoint
change screen
Setpoint change screen
Press “DONE” button to set the setpoint and exit back
to the main thermostat screen or wait for the screen to
automatically time out.
Press the up or down arrow buttons to
set the desired temperature setpoint
Pressing the up
or down buttons
will increment the
setpoint 1 degree.
Press and hold
the button to
ramp the setpoint.
72H 80C
72H 80C72H 80C
72H 80C
RUN
74
OFF
AUTO
MODE
FAN
Set to
Set toSet to
Set to
72
Heat
Done
MO
DE
FAN
Setpoint
being
changed

RCS TBZ48 Specifications

General

Brand	RCS
Model	TBZ48
Category	Thermostat
Language	English