RDA FirePro V2 - Page 18

Door control
FireProV2
Manual
Please keep this manual with attachments carefully!
17
9.10 Connecting LIGI 01-PNP light curtain:
Transmitter
Receiver
Brown:
10-30V DC (X10 +24V)
Blanking
on *
Blue:
0V DC (X10 GND)
Brown:
10-30V DC
X10 +24V
Blue:
10-30V DC (X10 +24V)
Blanking
off**
Blue:
0V DC
X10 GND
Brown:
0V DC (X10 GND)
White:
Synchronization
> Receiver
White:
Synchronization
> Transmitter
Black***:
Test
> X13
Black:
PNP output
> X10-2
Table 1
* Connecting with door function (Blanking): Yellow + green LED on transmitter
* * Connecting without door function: Green LED on transmitter
* * * See table 2 for test function (Use option 3 in combination with P-CAP)
To connect and set Test function:
Transmitter
Option 1:
Black
Siren output
Test input
> X13-NC (Siren)
Test 24V DC
> X13-C (Siren)
Parameter 5.1 > 5 “Test function light curtain”
Option 2:
Black
Alarm output
Test input
> X13-NC (Alarm)
Test 24V DC
> X13-C (Alarm)
Parameter 5.3 > 2 “Test function light curtain”
Option 3:
Black
SD Close output
Test input
> X14-NC
Test 24V DC
> X14-C
Parameter 2.6 > 3 “Test function light curtain”
Table 2
Fine adjustment Position:
By making the transmitter's black wire more than 15 sec power-less (from the + 24VDC), the
tuning mode is turned on. On the transmitter the green and yellow LED will flash alternately and
on the receiver the green LED must be lit and the red will blink. The faster the red LED flashes the
better the adjustment. If the green LED flashes, the adjustment is too bad for use!
Exit mode by reconnecting the black wire to + 24VDC.