Need help?Do you have a question about the ReadyMadeRC Anaconda and is the answer not in the manual?
General| Brand | ReadyMadeRC |
|---|---|
| Model | Anaconda |
| Category | Toy |
| Language | English |
Insert T-Nuts into motor mount and landing gear plates.
Press the fuselage halves together and secure with tape.
Secure the nose gear and steering servo anchor in the fuselage nose.
Install rear landing gear anchors on the fuselage bottom.
Assemble the nose gear with its control horn.
Insert and secure the steering servo in its housing.
Glue aileron servos into the wing and trim foam for movement.
Install and center the ruddervator servos and control horns.
Insert CF spars into the assembled main wings.
Insert the male stereo side of the tail booms into the wing anchors.
Slide ruddervators onto the tail booms and tighten clamps.
Place the assembled wing and tail onto the fuselage.
Set up V-Tail mixing or Y-harness connection in the transmitter.
Verify the center of gravity is at 45mm behind the leading edge.
Set control surface throws and consider elevator-to-flap mix.
To Next Page