ReadyMadeRC Anaconda - Table of Contents

Thank you for purchasing the RMRC Anaconda! It is important to read the manual in its
entirety before your maiden flight. This model is not intended for new or beginner pilots. It
requires a large, smooth takeoff/landing area and does not have self-correcting tendencies that
most new pilots require. Please obey all current laws and use common sense for safety when
operating.
Ready Made RC Support: If you have any issues with your aircraft or questions, please direct
them to our support system located at www.readymaderc.com/support and we would love to
help you out!
Note: We reserve the right to modify information presented and cannot be held liable for errors
within.
Table of Contents:
 Parts list for KIT: 3-7
 Parts list for PNP: 8
 Fuselage Assembly: 9-16
 Wing Assembly: 17-22
 Tail Assembly: 22-27
 Final Assembly for KIT and PNP: 28-31
 Setup Tips: 31-32
Required to operate:
 Motor – 3520 750-950KV*
 Propeller – 13-15”
 ESC – 80A*
 Servos
o 2x (Ailerons)*
o 2x (Elevator/Rudder)*
 2x (Flaps – Optional)Batteries – 4s 8,000-20,000 mAH
*Included in PNP
Required for build:
 Epoxy or personal choice of glue
 Phillips screw drivers
 1.5 and 3mm hex tools
 Hobby Knife
 Masking or Painter’s tape
 Servo Centering Tool
 Blue Thread Locker