ReadyNet AC1200MS - Page 6

Version 1.0 P a g e | 3
2
Step 1. Pick up phone and press “****” to start IVR.
Step 2. Choose “2”, and the AC1200MS reports current WAN Port IP Address.
Step 3. Input the new WAN port IP address with the end char #.
 Using “*” to replace “.”, user can input 192*168*20*168 to set the new IP address
192.168.20.168.
 Press # key to indicate you have finished.
Step 4. Report “operation successful” if user operation is correct.

 If at any time you want to quit, press “**”.
3
Step 1. Pick up phone and press “****” to start IVR.
Step 2. Choose “3”, and the AC1200MS reports the current WAN port subnet mask.
Step 3. Input a new WAN port subnet mask with the end char #.
 U
sing “*” to replace “.”, user can input 255*255*255*0 to set the new WAN port subnet mask
255.255.255.0.
 Press # key to indicate you have finished.
Step 4. Report “operation successful” if user operation is correct.

 If at any time you want to quit, press “**”.
4
Step 1. Pick up phone and press “****” to start IVR.
Step 2. Choose “4”, and the AC1200MS reports current gateway.
Step 3. Input the new gateway with the end char #.
 Using “*” to replace “.”, user can input 192*168*20*1 to set the new gateway 192.168.20.1.
 Press # key to indicate you have finished.
Step 4. Report “operation successful” if user operation is correct.

 If at any time you want to quit, press “**”.
5
Step 1. Pick up phone and press “****” to start IVR
Step 2. Choose “5”, and the AC1200MS reports current DNS
Step 3. Input the new DNS with the end char #
 Using “*” to replace “.”, user can input 192*168*20*1 to set the new gateway to
192.168.20.1
 Press # key to indicate you have finished
Step 4. Report “operation successful” if user operation is correct.

 If at any time you want to quit, press “**”.
6
Step 1. Pick up phone and press “****” to start IVR.
Step 2. Choose “6”, and the AC1200MS reports “Factory Reset”.
Step 3. Prompt "Please enter password", inputting password is the same as in operation 1.
 If at any time you want to quit, press “*”.
Step 4. Prompt “operation successful” if the password is correct.
Step 5. Press “7”, reboot to make changes effective.
7
Step 1. Pick up phone and press “****” to start IVR.
Step 2. Choose “7”, and the AC1200MSs report “Reboot”.
Step 3. Prompt "Please enter password", inputting password is the same as in operation 1.
Step 4. The AC1200MS will reboot if the operation is correct.